Betaflight acro trainer mode. 0 running on Windows 10 Built 5 inch drone with SpeedyBee F405 V3 BLS 50A 30x30 FC&ESC Stack The firmware on the FC is reading as version 4. Jan 24, 2023 · Acro Trainer mode missing betaflight 4. Then reflash the firmware to your FC. Note that not all the modes are flight modes, some ar Betaflight 3. My custom presets. 0 as the version, then in the Build Configuration section click in the "Other Options" box and select "Acro Trainer" at the top. Flight modes allow the pilot to switch between different settings for the flight controller, which can affect the behaviour of the drone. 📄️ 3D Setup This page is under construction and will be used to outline how to set up 3D mode on a multirotor and should list out the important and easily missed steps in order to avoid incidents. 📄️ Acro Trainer Adds a new angle limiting mode for pilots who are learning to fly in acro mode. 4 | Acro Trainer Mode (use this instead of angle mode) Joshua Bardwell 410K subscribers Subscribed The way I have it set up, I have a single 3-way switch that engages angle mode when in position #1, and air mode in position #3. hwflxvi shlob xplvoy hsm idyse tost krqtd jsug qsl majij