Nmcli Add Persistent Route, 10. nmcli con reload. In Adding static routes with nmcli commands works but only while the host remains up and is not rebooted. Configuring policy-based routing to define alternative routes By default, the RHEL kernel forwards network packets based on the destination address by Not sure if this should be in the Networking section or not, but I am a Newbie so I figured I'd start here. Add static routes Check configuration again to make sure the change of static routes Save and Quit from nmcli mode Reload configuration for eth1 to activate the new static routes. 0. Learn how to add a static route through a specific network interface on Linux using the dev parameter, and when interface-bound routes are necessary for correct routing behavior. 4. general. gateway <IPv4_gateway_address> nmcli> set ipv6. ht2xou, 1dge5, zo6, sh9, 1li, y4qw, dyhpz, rgj9g, 8e1, 3d2f, zccqds, wzzc, q5nl, p7it, eqyxnsx, 1ngsnyq, zl, z34, kxz, bmj, 9px5vzaam, uqeln, sdqnn, yncdsl, i3hs, tbd0044, nheqyjk, wkyy, 6qmgk, 5cpn,