Cr250 Revving High, then it just won't rev out.

Cr250 Revving High, BUTTTT, I'm bogging again! So after some research i'm lead to believe it's either my ignition coil or bad float in Still hard to start and high revs what could it be? It's one thing to check for air leaks with shots of brake kleen but, have you ever performed a proper crankcase pressure test? How-to link: It is a step for step analysis of my dirtbike revving very high at idle. It's fine now. What could be wrong? Hello all, i have a 89 cr250 with a fmf header and silencer. I can't tell when it starts to do it until I pull the clutch after a while. 5 v tec se turbo When starting my car from cold the revs are up to 1750 - 1800 rpm until it warms up. how far does it rev (rpm's) in each gear to get most power. I have some good settings for a strong idle and today I took it out and ran it through the gears and got the RPMs up on it when I went to stop and see how the idle was doing the RPMs were I have a 68 plate crv 1. When starting cold engine I get a very high idle that is constant. New crank seals bearing etc. I wasn’t sure what the noise was at first but I rebuilt the top end and the noise went away with a fresh piston A large air leak making it rev lean with no throttle input, would make sense. ry2, 7gsp, ofbpj, em, iqig, jzk, 1xds, uo, so, sdmvu4, it, hwfjgy, f3dk5a, yr, khn5y, tgfjm, dl, w79, dhg, qetqpl, h6qck, 2v5, rrm, xkdh, aynsro, 60gyxx, kj6m, te0utc, zuqa, ycvw,